Okay, long story short - welder was raising gas tank on the 01, and tipped a hole in a rear brake line. I replaced the line, but the flare to the BCM on the inside of the frame is wrong and leaks like cray. I bought a cheap flaring tool, and have presumed the way it is used, but id still like a bit of help.
Who has done this that can give me some tips and instructions? And if anyone can guide me to the correct size the line needs to be flared to i would greatly appreciate it. HELP!
Also...anyone from DFW that can do this hit me up...
:adjusted:
Who has done this that can give me some tips and instructions? And if anyone can guide me to the correct size the line needs to be flared to i would greatly appreciate it. HELP!
Also...anyone from DFW that can do this hit me up...
:adjusted: