NNBS DIY Fog Light Wiring Harness
- Thread starter SilveradoCowboy93
- Start date
Looks good so far, I'd only suggest running that through some sort of wire loom though. Where are you running the power wire to?
The fuse block with the connector that fits right into the fog lamp fuse , and yea I'm going to put something over it to protect it
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Before
After!
Putting LTZ grill and 20" RC light bar on tomorrow!
Sent from my iPhone using Tapatalk
Putting together the fog wiring harness was actually pretty simple I just made the ground wire A little too short but I just ended up cutting it and making it longer, the pigtails I got were not long enough. Then wired it straight to the Fog Relay and added the Light switch with the fog option and it worked perfect
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Looks loads better man, you should look into clearing your headlights next!
What's the best way to clear them myself? Throw them in the oven and let the glue get loose and cut the open or just buy new ones already cleared?
Sent from my iPhone using Tapatalk
Most people just cut them open. The glue on yours doesn't respond well to baking iirc. I cut mine open with a Dremel.
Damn that seems a little sketchy.. I'll look into it though
Sent from my iPhone using Tapatalk
It's not as bad as it sounds. There are Dremel cutoff wheels specifically for plastic. Best advise I can give you is to take your time. There's a video on YouTube that shows the whole process.
I cleared mine myself as well. Dremel and black silicone. YouTube has 2 videos of the process from Phil at FastHeadlights. If not he will do them for you. He does great work. Look him up.
I keep telling you that I can make you one whenever you are ready fool.